Medium induction heater

High heating capacity of up to 120 kg bearing

The SKF medium induction heater TIH 100m has the same high standards of efficiency and performance as the smaller heater TIH 030m, combined with increased capacity. The advanced design of the power electronics allows features of accurate electric current control, cut-outs to avoid overheating and controls on rate of temperature increase.

Placing the induction coil outside the heater’s housing allows the heating of bearings weighing up to 120 kg (264 lb). The heater is equipped with thermal overheating protection to reduce the risk of damage to the induction coil and the electronics. In addition to temperature mode, the TIH 100m is equipped with a time mode for heating components other than bearings. The heater is supplied standard with three yokes and is available in two executions: 230V/50-60Hz or 400-460V/50-60Hz.

Standard swivel arm for large size yoke
Capable of heating a 97 kg (213 lb) bearing in less than 20 minutes, saving time and energy
2-step power setting and smaller yokes allow heating smaller bearings safely and at lower power consumption
Temperature mode pre–set at 110 °C (230 °F) to help prevent bearing over–heating
Automatic demagnetization
Foldable bearing support arms allow larger diameter bearings to be heated, and reduce the risk of the bearing toppling during heating