Strong back pullers

Easy bearing dismounting even in the tightest spaces

The SKF TMBS E strong back pullers facilitate dismounting of bearings in applications where the use of traditional jaw pullers is restricted due to lack of space or where the application demands a long reach.

TMBS 100E and the TMBS 150E bearing extractors are equipped with a hydraulic spindle, which allows for effortless application of force up to 100 kN (11.2 ton US). The TMBS 50E is equipped with a mechanical spindle for force generation.

Special separator design allows the puller to be easily inserted between the bearing and the shoulder on the shaft
The spring-loaded centre point of the hydraulic spindle allows easy puller centring minimizing the risk of shaft damage
The firm grip behind the bearing’s inner ring reduces the force required to dismount the bearing
The hydraulic spindle is equipped with a safety valve, which minimises the risk of puller overload
A hydraulic spindle stroke of 80 mm (3.1 in.) helps facilitate dismounting in one operation
SKF TMBS 50E is equipped with a mechanical spindle for force generation
SKF TMBS 100E and the SKF TMBS 150E are equipped with a hydraulic spindle, which allows for easy application of force up to 100 kN (11.2 US ton)
Supplied with hydraulic spindle extension pieces to allow quick adaptation to pulling length
SKF TMBS 100E and SKF TMBS 150E are supplied with extension rods to allow quick adaptation to pulling lengths up to 816 mm (32.1 in.)

Εxplore our wide range of products

Get in touch

Our Address